If you would like to come visit we require an appointment be made at least 24 hours in advance of your arrival. We only have appointments available in the afternoon.

Walk-ins are not allowed.

Scratch-N-Dent Blower - 2.5"

Out of stock

Tested

Broken casting shown in picture and one screw area that holds sides together.

Still very functional

See pictures

Item #
SD Blower 3-1
$125.00

Tested

Broken casting shown in picture and one screw area that holds sides together.

Still very functional

See pictures

Tested

Broken casting shown in picture and one screw area that holds sides together.

Still very functional

See pictures

Tested

Broken casting shown in picture and one screw area that holds sides together.

Still very functional

See pictures

Forge blowers (also known as forge fans).

While this blower is highly popular with forge builders, there is no one blower that works for all situations.  Therefore we cannot refund shipping unless product is defective, which would be analyzed upon return of product.

  • all aluminum body
  • Inlet: - 2½" Inside diameter
  • internal pressure - 680 pascals (pa) = 2.7" WCP
  • millimeter H20 (mmAq) - 69.3426
  • approx. 125 CFM when damper is full open
  • 110 volt
  • 260 watt
  • 60 cycles
  • 1.6 amp
  • 3600 RPM
  • total height approx. 10.5"

****Must be mounted upright - Feet at the bottom - as pictured***

ALL PRESSURES ARE APPROXIMATE

****Must be mounted upright - Feet at the bottom - as pictured***

***Variable Speed controller NOT RECOMMENDED**

Write Your Own Review
You're reviewing:Scratch-N-Dent Blower - 2.5"
Your Rating