Build Your Own Hydraulic Forging Press

In stock
Building a Hydraulic Forging Press by Jim Batson
Item #
Batson press
$32.00
Building a Hydraulic Forging Press by Jim Batson
Building a Hydraulic Forging Press by Jim Batson
Building a Hydraulic Forging Press by Jim Batson

Build Your Own Hydraulic Forging Press by Jim Batson

  • Newest edition
  • Soft cover
  • copywrite 1994
  • Dimentions: 8 1/2" x 11"
  • Pages: 46
  • Illustrations: 35
  • ISBN 978-0-578-21181-7

This book and drawings are designed to help you build your own 24 ton Hydraulic Forging Press. A two horsepower 220 volt single phase motor running at 1725 RPM powers a 5.5 gallon per minute "Hi-Lo" hydraulic pump. Ram force of 24 tons is applied by a 5" diameter double acting hydraulic cylinder at 2500 psi pressure. The movement of the ram die is controlled by a 4 way, 3 position hydraulic valve. The length of the ram stroke is 8". The maximum speed of the ram is 1.1 inches per second. The ram speed can be doubled by using a 5 horsepower electric motot running at 3600 RPM. A section is included which will enable you to alter a Log Splitter for use as a Forging Press

 

 

Write Your Own Review
You're reviewing:Build Your Own Hydraulic Forging Press
Your Rating