Blade Tongs
In stock
Available in several sizes.
designated size is width of flat stock
Item #
bladetongs
Available in several sizes.
designated size is width of flat stock
Available in several sizes.
designated size is width of flat stock
Available in several sizes.
designated size is width of flat stock
Off-Center 18" blacksmith tongs to hold flat stock as you create your blade.
Sometimes called "Z v-bit" tongs" due to the offset. These knife making tongs are offset just enough to bypass the pivot joint so you can hold anywhere along your blade blank.
Sized to hold 3/16" or 1/4" thick flat bar at the designated width. Reins will be approx. 1-1/2" - 2" apart with stock in the specified size stock in the jaw
Blacksmith tong set includes 4 smallest sizes Drop Forged in the USA
Write Your Own Review
